济南科邦机械设备有限公司您身边的济南空压机厂家!
18765879198

首页>企业新闻
工厂配套空压机供气方案的确定
Time:2018-11-08 16:18:00       来源:http://www.jnkbjx.com/      

方案一、设区域性压缩空气站供气。在工厂规模较大,压缩空气用气量大且主要用户又较分散时,为减少管网的压力损耗和保证重点用气的使用,常用此种方案,对区域站房之间应有管道连通,以达到互相调节负荷,互为备用的目的。

First, set up regional compressed air station for gas supply. In order to reduce the pressure loss of pipeline network and ensure the use of key gas when the plant is large and the compressed air consumption is large and the main users are dispersed, this scheme is commonly used. Pipelines should be connected between regional stations to achieve the purpose of adjusting load and reserving each other.
方案二、设几种压缩空气站供气。这种方案主要用于中小型工厂和用气较为集中的大型工厂。
Plan two, set up several compressed air stations for gas supply. This scheme is mainly used for small and medium-sized factories and large factories with relatively concentrated gas consumption.
方案三、就地供气方案。当工厂用气量不大,用气点少而分散时,可考虑用小空压机机组就用起点附近安置。
Scenario three, on site gas supply plan. When the gas consumption is small and the gas point is small and scattered, the small air compressor unit can be considered to be installed near the starting point.
方案四、集中与分散结合的供气方案。在某些大、中型工厂里,其主要压缩空气用气较集中,次要较分散。特别是夜间用气较少,宜采用此方案。
济南空压机
Plan four, centralized and decentralized gas supply plan. In some large and medium-sized factories, the main compressed air is more concentrated and less dispersed. In particular, it is advisable to use this scheme at night for less gas consumption.
以上四种是比较常用的方案,另外还有一些情况,多采用下面的办法:
The above four are the more commonly used schemes. In addition, there are other situations.
当工厂需要供应不同的压缩空气时,而低压用气量有较大时,应考虑采用不同压力等级的供气系统,配置不同压力的空压机。以减少降压引起的能量浪费,但供气压力等级一般不宜超过二中,以减少初期设备的投资。
When factories need to supply different compressed air, and when the low-pressure gas consumption is large, different pressure levels of air supply system should be considered, and different pressure air compressors should be installed. In order to reduce energy waste caused by depressurization, the pressure level of supply gas should not exceed No. 2 Middle School in order to reduce the investment of initial equipment.
当工厂有部分用气点需要供应较高品质的压缩空气时,可考虑单独用一台无油润滑十空压机。也可以考虑用集中供出的压缩空气,将部分后处理设备处理后来供气,具体采用哪种方法,应视具体用气量的大小和用气点的位置等,经综合经济比较后确定。
When some gas points in the factory need to supply high quality compressed air, we can consider using a single oil-free ten-air compressor. It is also possible to consider the use of centralized compressed air to supply gas after the treatment of some post-processing equipment. The specific method should be determined by comprehensive economic comparison, depending on the size of the specific gas consumption and the location of the gas point.
有了济南空压机上面的小总结,希望对广大客户有所帮助,如果有什么不理解的或者寻求帮助的请点击我们的官方网站:http://www.jnkbjx.com或者来电咨询,我们会尽全力为您解决
With the summary above Jinan air compressor, I hope it will be helpful to our customers. If you don't understand or ask for help, please click on our official website: http://www.jnkbjx.com or call for consultation. We will try our best to solve it for you.

电话:0531-85963300     手机:18765879198   地址:济南市天桥区无影山中路130号重汽彩世界     备案号:鲁公网安备 37010502001004号 >

版权所有:济南科邦机械设备有限公司 济南科邦机械主营::济南空压机及配件 网址:http://www.jnkbjx.com    技术支持:诺商信息

鲁公网安备 37010502001004号