济南科邦机械设备有限公司您身边的济南空压机厂家!
17553037111   18765879198

首页>企业新闻
如何辨别济南空压机的润滑油有没有变质?
Time:2019-07-22 15:49:55       来源:http://www.jnkbjx.com/      

  一、济南空压机开机前的准备工作

  I. Preparations for Jinan Air Compressor before Start-up
  (1) 检查空压机各机械零部件和管道能否联接牢靠,如有松动现象,及时处置。
  (1) Check whether the mechanical parts and pipes of the air compressor can be firmly connected. If there is loosening, dispose of it in time.
  (2) 检查空压机油位高度,机组在停机时的油位高于油表上的位置时,机组即可正常开机运转,即使机组运转起来后,油位一下子看不到也并不影响机组的正常运用。
  (2) Check the oil level of the air compressor, when the oil level of the unit is higher than the lowest position on the oil gauge at the time of shutdown, the unit can start up normally. Even if the unit is running, the oil level can not be seen at once, it will not affect the normal operation of the unit.
  (3) 用手按规则方向转动联轴器数转,确保机组转动灵敏。
  (3) Rotate the coupling in a regular direction by hand to ensure that the unit rotates sensitively.
  (4) 检查电气能否契合平安规程的请求,确认后接通机组电源。
  (4) Check whether the electricity meets the requirements of safety regulations, and connect the unit power after confirmation.
  二、螺杆空压机的启动
  II. Start-up of Screw Air Compressor
  (1)空压机在初开车或空压机及其系统设备检修后重新起动时应遵照下述程序:
  (1) The following procedures shall be followed when the air compressor is restarted after the initial start-up or after the overhaul of the air compressor and its system equipment:
  a) 检查一切的阀能否均处于适宜的位置及正确的启闭状态;
  (a) Check whether all valves are in the proper position and in the correct opening and closing state;
  b) 除去一切为平安维护而装置的维修附件(如盲板)及维修用标志牌;
  B) Remove all maintenance accessories (such as blinds) and maintenance signs for safety maintenance;
  c) 检查系统并除去其内的外来异物;
  C) Check the system and remove foreign bodies from it;
  d) 翻开并再次关闭排污阀;
  D) Open and close the drain valve again;
  e) 盘车少一圈以确保无机械干预;
  (e) Driving at least one lap to ensure no mechanical intervention;
  (2) 如机组在送电后,机组控制屏没有显现相序错误,则可按下“启动”按钮,正常开机,开机后请再次确认驱动电机以及旋转设备的旋转方向正确,并肯定一切的平安维护安装均处于适宜的操作状态
  (2) If there is no phase sequence error in the control panel of the unit after power transmission, the "start" button can be pressed to start normally. After starting, please confirm the correct rotation direction of the driving motor and rotating equipment again, and make sure that all safe maintenance and installation are in the proper operation state.
济南空压机
  济南空压机
  Jinan air compressor
  螺杆紧缩机主机在任何状况下都严禁反转!下列状况必需先确认主机转向:
  Screw compressor mainframe in any situation is strictly prohibited reversal! The following conditions must be confirmed before the main engine is turned:
  1)新机开机调试;2)电源线重新接线;3)总电源换相
  1) Start-up and debugging of the new machine; 2) Rewiring of the power cord; 3) Commutation of the total power supply
  关于因无视这些正告和留意事项而招致的任何损坏或伤害,制造商概不承当任何义务
  The manufacturer shall not undertake any obligation with respect to any damage or injury caused by ignorance of these notices and precautions.
  4) 机组启动过程完成后空压机即进入自动控制状态。
  4) After the start-up process of the unit is completed, the air compressor will enter the automatic control state.
  三、螺杆空压机的运转
  III. Operation of Screw Air Compressor
  1) 机组正常运转后,检查一下机组内各处有无漏油漏气现象,如有则立刻停车处置。
  1) After the normal operation of the unit, check whether there is oil leakage and air leakage in all parts of the unit, and if so, stop immediately for disposal.
  2) 检查排气压力,排气温度等运转参数能否正常。
  2) Check whether the operating parameters such as exhaust pressure and exhaust temperature are normal.
  3) 做好工作运转记载,比拟各运转参数能否一直正常,如有反常现象应及时停机并剖析查找缘由。
  3) Make a good record of the operation and compare whether the operation parameters are normal. If there are abnormal phenomena, stop the machine in time and analyze the reasons.
  四、空压机的停机
  4. Shutdown of Air Compressor
  3.4.1 如需求中止运转机组,则只需按下停车按钮后,紧缩机自动卸载约20-30秒后停车。没有特别缘由,不要用急停按钮停机
  3.4.1 If the unit needs to stop running, only press the stop button and the compressor will automatically unload for about 20-30 seconds before stopping. For no particular reason, don't use the emergency stop button to shut down.
  3.4.2 切断机组电源
  3.4.2 Cut off the power supply of the unit
  五、日常维护便当
  5. Easy maintenance
  1、紧缩机应便于装置
  1. Compressor should be easy to install.
  从装置的便当性来思索,如今市场上有挪动式、便携式、免装置的空压机,所选的紧缩机在满足用气的前提下体积要小,重量要轻,便于安装。对用气场地狭小(船用、车用)的用气单元,应选立式紧缩机;用气场所有长间隔变化(超越500米)的用气单元,则应思索挪动式紧缩机。
  Considering the convenience of the device, there are movable, portable and device-free air compressors on the market today. The compressor selected should be small in size, light in weight and easy to install under the premise of satisfying the demand for gas. Vertical compressors should be selected for the Air-using units with narrow space (marine or vehicle) and movable compressors should be considered for the Air-using units with long intervals (over 500 meters).
  2、紧缩机的后期维护便当、本钱低
  2. Easy maintenance and low cost in the later period of the compressor
  选择紧缩机时要充沛思索到紧缩机日常维护的便利性及维护本钱。尽量选用易损件(主要是机油与滤芯)改换周期长、通用性强、售后效劳期长的紧缩机。
  When choosing the compressor, we should consider the convenience and cost of daily maintenance of the compressor. Choose as far as possible fragile parts (mainly oil and filter elements) to replace the long cycle, versatility, long service life of the compressor.
  以上是济南空压机制造商为大家整理的相关内容,想要了解更多内容,欢迎访问网站:http://www.jnkbjx.com
  The above is the related content of Jinan air compressor manufacturer. For more information, please visit the website: http://www.jnkbjx.com.

电话:0531-85963300      手机:17553037111   18765879198    地址:济南市天桥区无影山中路130号重汽彩世界     备案号:鲁ICP备18021911号-1

济南科邦机械设备有限公司 济南科邦机械主营::济南空压机及配件 网址:http://www.jnkbjx.com     

鲁公网安备 37010502001004号